When you are installing a new driveway or replacing the existing driveway, you are required to make all the required preparations correctly. Take your time to review and understand the preparations required so that there are no glitches or confusions during the installation process. Let us look at all the preparations required for a successful installation of the driveway.
The preparation required will vary depending on whether it is the first-time installation or re-installation on an existing drive way. If this is a first-time installation then you may need a little longer for the substrate preparation. The ground below should be hard and firm so that when you pave the resin bound gravel supplies you will be able to get a strong driveway. The resin bound paving itself cannot take any load on its own as this is just a finishing substance and not a load bearing material. Ensure therefore before the installation day, you have a firm substrate. You will not have this part of the preparation if you are replacing the existing driveway. However, if you are installing on the existing driveway, then you need to sweep the surface clean. There should be no sand or debris on the driveway because such things will affect the quality of bonding between the substrate and the new driveway. If your existing driveway should have any oil spills or chemical spills, you need to clean them too.
Look for the most trustworthy resin bound manufacturers to source your supplies. You should look for resin bound DIY kits from reputed manufacturers. If you get good quality supplies for your needs then you will not have any issues with the installation process and the final outcome will also be very impressive. You are required to take a lot of time to review and screen your suppliers and this is an important step in the preparation. Select suppliers who can deliver your orders on time because if they delay your orders then you will not be able to use execute the project as planned.
The next factor you need to take into consideration is the selection of the right day for installation. It is important that you choose a non-rainy day. If it is a wet day then the setting process would be disrupted. In case it rains heavily during the installation process, the installation area will be wet and soggy and the resin will not bond with the substrate and this will result in poor quality driveways. You should not let such mistakes happen but look for a dry and sunny day. It is also important that it is not too hot either. If it is too hot the resin will dry much faster than it should making the installation process all the more challenging.
By paying attention to all these basic factors you will be able to save yourself from all the unnecessary glitches. So go ahead and select the right suppliers and follow the above installation guidelines.